HOME         CATALOGUE          TECH INFO          SHOW YOUR RIDE         CALCULATORS          ABOUT US         GALLERY        CONTACT US
   

5 axis CNC Porting Service (4)
Books and Manuals (1)
Camshafts and Accessories (8)
Cylinder Heads - Aluminum (6)
Cylinder Heads - Aluminum D-port (2)
Cylinder Heads - Cast Iron (2)
Distributor Gears (2)
Fasteners (2)
Fuel Pumps and Accessories (1)
Gaskets/Seals (14)
Guide Plates (1)
Intake Manifolds (5)
Lifter Bore Brace (2)
Lifters (3)
Limited Time Offers (0)
Mini Starter (1)
Oil Pans/Pumps & Accessories (8)
Pistons (2)
Pushrods (2)
Rocker Arms and Accessories (6)
Timing Sets (1)
Vacuum Pumps and Accessories (3)
Valley Pans (1)
"Stump Puller" Custom Hyd. Roller Cam



 
The name speaks for itself, this cam works well in mild 455-474ci with ported heads. Provides plenty of vac. for power accessories and makes very strong power off idle to 5500rpm. This cam was designed with RA/HO exhaust manifolds in mind and gives up very little performance with the manifolds over a 4 tube header. It also works well in moderate 389-428ci combo's. For more information shoot us an e-mail at techsupport@sdperformance.com

In a recent dyno test this cam installed in a 464ci engine with 9.5 to 1 compression, a set of our 250-260cfm CNC ported #11 cast iron heads, CNC ported cast iron Q-jet intake and a prepped Q-jet carb made 503hp and 575+ lb/ft of torque on 91 octane.



230/236 dur @ .050" lift .590"/.592" lift with 1.52 ratio rockers 112 lobe sep


$ 389.95

$ 534.23



   
  * SD Performance reserves the right to change prices without notification.  
     
  Accepted.