HOME         CATALOGUE          TECH INFO          SHOW YOUR RIDE         CALCULATORS          ABOUT US         GALLERY        CONTACT US
   

5 axis CNC Porting Service (4)
Books and Manuals (1)
Camshafts and Accessories (8)
Cylinder Heads - Aluminum (6)
Cylinder Heads - Aluminum D-port (2)
Cylinder Heads - Cast Iron (2)
Distributor Gears (2)
Fasteners (2)
Fuel Pumps and Accessories (1)
Gaskets/Seals (14)
Guide Plates (1)
Intake Manifolds (5)
Lifter Bore Brace (2)
Lifters (3)
Limited Time Offers (0)
Mini Starter (1)
Oil Pans/Pumps & Accessories (8)
Pistons (2)
Pushrods (2)
Rocker Arms and Accessories (6)
Timing Sets (1)
Vacuum Pumps and Accessories (3)
Valley Pans (1)
CNC Wide Port Victor Intake



 
Edelbock Victor 4500 intake, CNC ported runners and plenum with hand blending and finishing (dyno testing showed 20-25hp gain over as cast cloverleaf plenum) to properly match our CNC ported wide port Edelbrock heads.
Each runner is flow tested to make sure it flows what it should to make max power.
In addition to the porting, we CNC machine the top of the intake runners for valve cover clearance, clearance the center runners for bolt clearance as well as separate the water crossover for easier port alignment.
If you have ever tried installing a Victor intake out of the box, the extra steps we take to make this manifold a bolt on will save you a ton of time and hassle. ($595.00 using customer supplied Victor intake)


$ 895.00

$ 1253.00



   
  * SD Performance reserves the right to change prices without notification.  
     
  Accepted.